DIGITAL DELAY 1020-SCR Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Панель керування DIGITAL DELAY 1020-SCR. DIGITAL DELAY 1020-SCR 10 сторінок.

Setting the Back-light Intensity

To set the back-light Intensity press the 9 key on the keypad. The left most digit will show the

current setting. To change the setting, press the * key on the keypad followed by the new setting (1-9).

The smaller the number, the dimmer the back-light will be.

The keypad is made up of 12 keys, 10 numerical and 2 function keys, that control all the

information pertaining to the Crossover Plus. The numerical keys 1-9 are used to view information stored

in memory. Also when used in conjunction with the function key * the numerical keys 0-9 are used to

enter new information. The function key # has three separate functions described below.

Selecting Displayed Information

The numerical keys1-9 are used with the text next to the small red L.E.D.s to select the displayed

information. This is done by pressing the number on the keypad that corresponds to the number for the

text of the desired information. For example, to display the "Delay 1 time" the 3 key would be depressed.

Pressing the 9 key will turn off all the red L.E.D.s and bring up the back-light intensity setting.

Function Key

The function key * is used with the numerical keys for entering new times or modes. For example

to enter a new Delay 1 Time, first press the 3 key on the keypad to bring up the current stored Delay 1

Time. Next press the * key on the keypad, the display will go blank indicating it is ready to accept a new

Delay 1 Time. Use the numerical keys to enter the new Delay 1 Time into the unit, leading zeros must be

entered. As the numbers are entered they will appear on the display indicating the number was accepted

and stored into memory. Once a new value is started it must be completed before any other function of

the delay box will work.

If an error is made while entering, press the * key to erase the last digit entered. This can be

repeated as many times as necessary until the display is blank.

Function Key #

The function key # controls three separate functions.

If pressed during a delay cycle, the delay cycle will be cancelled

and the unit will be reset. This constitutes a master reset for the

delay cycle.

If pressed while the unit is not running a delay cycle,"Their Dial-In"

will be displayed and set to all zeros, making sure the next run is

not on the previous opponent's Dial-In.

If the # key is held down while the power is being turned on, the unit

will go into a special test mode. This is described in Testing of the Unit.