DIGITAL DELAY 1020-SCR Інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Панель керування DIGITAL DELAY 1020-SCR. DIGITAL DELAY 1020-SCR 10 сторінок.

To display the How Late information press the 5 key on the keypad. The right three digits display

the How Late time. The left most digit will display an "8" if the transbrake released on Delay-2 (4-Digit).

The left most digit will be blank if the transbrake released on Delay-1 (Crossover). For example if the

number displayed is "8.012" and your reaction time was .510 on the time slip, add the How Late time to

the .510 for a total reaction time of .522 on the crossover delay.

To display the Tap information press the 6 key on the keypad. The left most digit shows the

programmable time (1 to 9 hundredths of a second) to be added to, or subtracted from the delay time

every time the Tap push button is pressed. The right two digits show the number of times the Tap push

button was pressed the last time it was used during a timing cycle. The Tap time will only affect the first

delay time started. To change the programmable time press the * key on the keypad. The left most digit

will now be blank and the unit can be switched between the Tap Up and Tap Down modes by pressing the

# key (arrow on means uump up, no arrow means tap down). After selecting the desired Tap Up or Down

mode enter the new number (1-9) for the programmable time.

NOTE: Both How Late and Tap information are stored in memory

until a new How Late or the Tap number replaces it.

Setting Push Button Mode and the

Push Button Interrupt Time

To set the Push Button Mode press the 7 key on the keypad. The left most digit will be either a

"1" or "2" to indicate which Push Button Mode the unit is in, when in Single Push Button Mode, the First

P.B. starts both the primary and secondary delays. When in dual Push Button Mode, one or both push

buttons can be used in any sequence. The First P.B. starts the primary delay and Second P.B. starts the

secondary delay. The two right digits show the programmable amount of time (00 to 99 seconds) that

after the transbrake releases, First P.B. and Second P.B. push button inputs are disabled. To change either

the Button Mode or the Interrupt Time first press the * key, then enter a "1" or "2" for the Push Button

Mode followed by a two digit number representing the Push Button Interrupt Time. For example "1 10"

would indicate single Push Button Mode with a 10 second Interrupt Time. If no Push Button Interrupt

Time is wanted, after pressing a "1" or "2" for the Push Button Mode enter "00" for the interrupt time.

How Late