Digital Dynamics LIONEL TRAINmaster LCRU Інструкція з монтажу Посібник з монтажу - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Приймач Digital Dynamics LIONEL TRAINmaster LCRU. Digital Dynamics LIONEL TRAINmaster LCRU 18 сторінок. Locomotive command receiver unit for single or dual ac motor locomotives

Друкувати сторінку

Wiring

LCRU and Engine Type

The LCRU is programmed via two pigtail wires, BLK and WHT, for different options with different

locomotive types. Refer to the table below and to the wiring diagrams for these options and how

to enable them.

MODE

STEAM w/ SMOKE

DIESEL w/ DIRECTIONAL

HEADLAMPS

DIESEL w/ STROBE

Note that later versions of the LCRU, specifically LCRU2 and R2LC, are programmed via CAB-1 for

operation with specific engine types and options. The LCRU will not respond to any of these

factory reset codes, and can be programmed only via the method described above.

WHT WIRE

BLK WIRE

GND

No Connect

Connect to BLK

Connect to WHT

Table 1. LCRU Programming

LCRU Installation Manual

REMARKS

Single Headlamp. Rear

Headlamp output drives

smoke unit.

Headlamps light in

direction of engine.

Rear Headlamp output

becomes strobe/MARS lamp.