Digital Dynamics LIONEL TRAINmaster LCRU 설치 지침 매뉴얼 - 페이지 7
{카테고리_이름} Digital Dynamics LIONEL TRAINmaster LCRU에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Dynamics LIONEL TRAINmaster LCRU 18 페이지. Locomotive command receiver unit for single or dual ac motor locomotives
페이지 인쇄Wiring
Wiring
LCRU and Engine Type
LCRU and Engine Type
The LCRU is programmed via two pigtail wires, BLK and WHT, for different options with different
locomotive types. Refer to the table below and to the wiring diagrams for these options and how
to enable them.
MODE
STEAM w/ SMOKE
DIESEL w/ DIRECTIONAL
HEADLAMPS
DIESEL w/ STROBE
Note that later versions of the LCRU, specifically LCRU2 and R2LC, are programmed via CAB-1 for
operation with specific engine types and options. The LCRU will not respond to any of these
factory reset codes, and can be programmed only via the method described above.
WHT WIRE
BLK WIRE
GND
GND
GND
No Connect
Connect to BLK
Connect to WHT
Table 1. LCRU Programming
LCRU Installation Manual
© Digital Dynamics
REMARKS
Single Headlamp. Rear
Headlamp output drives
smoke unit.
Headlamps light in
direction of engine.
Rear Headlamp output
becomes strobe/MARS lamp.
6