Bitstream ERIS-100 Посібник із швидкого старту - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Конвертер мультимедіа Bitstream ERIS-100. Bitstream ERIS-100 5 сторінок. Fiber opical converter - ethernet 10/100/mbps

Друкувати сторінку
Quick start manual, a detailed manual is on the enclosed CD or can be downloaded
from company's website www.bitstream.com.pl/en/
–
PoE++ version requires power supply of 52-57V DC to power the outdoor device
–
Power consumption 55mA at 48V DC
–
Voltage polarity - unrestricted
.4
With the switch No. 1 you can change the PoE mode on the RJ45 electrical port. By default, the
switch is set to OFF - Auto mode, so you can power external devices in the PoE ++ standard with
power up to 90W. Switching to ON position activates FORCE mode. In this mode, you can power
external devices without PoE standard up to 30W.
Switch no. 1 is not used in the device version without PoE.
ATTENTION!!! Setting the DIP-SWITCH No. 1 to the ON position (FORCE mode) in cases
where a device that does not support PoE is connected to the ERIS converter via UTP, may
damage the device port or in the worst case the whole device.
.5
The ERIS-100 is ready to operate automatically when the power is connected. When the power
supply is properly connected, the power LED should flash.
.6
The ERIS-100 device has been designed based on applicable standards and recommendations in
the field of data transmission, electromagnetic compatibility and safety of use.
.6.1
The device was designed pursuant to the standard EN 55022 class A, PN-EN-55024.
BITSTREAM devices are designated to functioning in closed premises.
Notice: This device is a class A device. In the residential environment may cause radio
frequency interference. In such cases, you can require the user to take appropriate measures.
.6.2
In respect to safety of service, BITSTREAM devices were designed and tested for operation
safety along with the EN 60950 standard.
Configuration and installation of the device should be executed by authorised persons
familiar with the service manual. The producer shall not be responsible for any occurrence that could
result from usage and installation that might not conform to this manual.
REV.
1.01
P
E
O
SUPPLY FOR
F
-
IRST START
UP
C
ONFORMITY TO STANDARDSAND RECOMMENDATIONS

Electromagnetic compatibility

Safety
User Manual ERIS-100
PD
DEVICES
2019.11.20
4/5