Bitstream ERIS-100 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} Bitstream ERIS-100에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bitstream ERIS-100 5 페이지. Fiber opical converter - ethernet 10/100/mbps

Quick start manual, a detailed manual is on the enclosed CD or can be downloaded

from company's website www.bitstream.com.pl/en/

–

PoE++ version requires power supply of 52-57V DC to power the outdoor device

–

Power consumption 55mA at 48V DC

–

Voltage polarity - unrestricted

With the switch No. 1 you can change the PoE mode on the RJ45 electrical port. By default, the

switch is set to OFF - Auto mode, so you can power external devices in the PoE ++ standard with

power up to 90W. Switching to ON position activates FORCE mode. In this mode, you can power

external devices without PoE standard up to 30W.

Switch no. 1 is not used in the device version without PoE.

ATTENTION!!! Setting the DIP-SWITCH No. 1 to the ON position (FORCE mode) in cases

where a device that does not support PoE is connected to the ERIS converter via UTP, may

damage the device port or in the worst case the whole device.

The ERIS-100 is ready to operate automatically when the power is connected. When the power

supply is properly connected, the power LED should flash.

The ERIS-100 device has been designed based on applicable standards and recommendations in

the field of data transmission, electromagnetic compatibility and safety of use.

.6.1

The device was designed pursuant to the standard EN 55022 class A, PN-EN-55024.

BITSTREAM devices are designated to functioning in closed premises.

Notice: This device is a class A device. In the residential environment may cause radio

frequency interference. In such cases, you can require the user to take appropriate measures.

.6.2

In respect to safety of service, BITSTREAM devices were designed and tested for operation

safety along with the EN 60950 standard.

Configuration and installation of the device should be executed by authorised persons

familiar with the service manual. The producer shall not be responsible for any occurrence that could

result from usage and installation that might not conform to this manual.

REV.

1.01

SUPPLY FOR

IRST START

ONFORMITY TO STANDARDSAND RECOMMENDATIONS

Safety

User Manual ERIS-100

DEVICES

2019.11.20

4/5