Siemens 3AH Інструкція з експлуатації - Сторінка 30

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Промислове обладнання Siemens 3AH. Siemens 3AH 38 сторінок. Vacuum circuit breaker operator module
Також для Siemens 3AH: Інструкції, монтаж, експлуатація, технічне обслуговування (33 сторінок), Експлуатація та технічне обслуговування установки (20 сторінок)

Overhaul

1 .3 Withdraw pin (48.5) from insu lating coupler (48) a n d

levers (48.6) .

1.4 Remove coupling pin from the eye bolt (36.3)

1.5 Free struts (28) from the pole head (20). Loosen the

strut hardwa re on the pole bottom (40) and swing

the struts forward and downward.

1.6 Loosen screws fastening the centering ring (28.1 ).

1.7 Remove bolt (31.2), lockwasher and l a rge washer at

stationary contact of the vacu u m interrupter.

1.8 Using a deep socket, loosen a n d remove hex cap

screw fastening the pole head to the post insulator.

Completely remove the pole head a n d set aside.

1.9 Grasp the vacuum interrupter (30) and withdraw

vertical ly. Assistance may be requ i red to work the

terminal clamp off the movable stem of the vacuum

interrupter. FORCIBLE TWIS T ING EFFOR T IS NO T

ALLOWED. If the terminal clamp (29.2) cannot be

easily rem oved, S TOP! , check to be certain hard

ware is loose, and that the term i n a l clamp (29.2) is

not binding.

Figure 20. Technique forTightening Vacuum l nterrupterTerminal Clamp Hardware

P osition of Torque Wrench to Avoid Undue Stressing

Moving Contact

Terminal Oamp

29.2

2. I n stalling a Vacuum Interrupter

NO T E: Replacement vacuum interrupter (30) will be re

ceived from the factory with an eyebolt (36.3) in place,

adjusted and torq ued to specific requ irements.

DO NO T AL T ERT HE ADAPT ER SETTING.

2.1 I nspect all silver plated connection surfaces for clean

liness. Clean only with a cloth and solvent.

Do not abra i d .

2.2 I n s e rt vacuum interrupter (30) into the lower pole

support (40). Slip terminal clamp (29.2) into posi

tion on the movable stem.

2.3 Align vacuum interrupter a n d fasten "finger tight"

using heavy flat washer, lock washer and bolt, (31.2).

3 6. 1

Vac uu m I nterr u pter

T orque Wrenc h

Direction

Fon:: e