Epson 1815p - PowerLite XGA LCD Projector Посібник користувача - Сторінка 14

Друкувати сторінку

Epson 1815p - PowerLite XGA LCD Projector Посібник користувача

PowerLite 1810p/1815p

❏

: Enter the IP address you want to assign to

IP address

the projector. It must be formatted like other addresses

on the network. The last octet should be unique.

❏

: For example: 255.255.255.000, but this

Subnet mask

depends on how your network is set up.

❏

: Enter the IP address that was

Gateway address

assigned to the access point or AirPort base station when

it was set up.

8. When you're done making these settings, select

, and then

Setup complete

save the changes. Press

Now you're ready to set up your computer for wireless

projecting. Go to "Configuring the Network Settings for

Windows" in the next section, or go to "Configuring the

Network Settings for Macintosh" on page 16.

Note: For specific details about your network, please consult your

network administrator. If you don't know your gateway or access

point address, see page 16. If you're using AirPort, start the AirPort

Admin utility, select your base station and click

click the

tab to see your base station's IP address.

Network

Configuring the Network Settings for Windows

Before connecting to the projector, you need to make sure the

settings for your computer's wireless card or adapter match the

settings you entered for the projector.

1. Access your wireless network Properties window. For

example, in Windows XP you would click

Panel > Network and Internet Connections

the

Network Connections

this:

Right-click and select Properties

PowerLite 1810p/1815p

Return

to confirm that you want to

Yes

to exit the menu system.

. Then

Configure

Start > Control

. Then click

icon. You see a screen similar to

2. Right-click the

select

Properties

3. Click the

Configure

4. Click the

Advanced

5. Check your wireless card's or adapter's device settings.

(Depending on the type of card or adapter you're using,

some of the settings may be different than those listed here.)

❏ Set the Network Type to

❏ Set the SSID to match the name assigned to the access

point (which should also match the projector's ESSID).

❏ Make sure Encryption is

encryption on the projector.

6. Click the

General

or adapter is enabled.

7. When you're done, click

dialog box.

3/08

Wireless Network Connection

. You see a screen similar to this:

button.

tab. You see a screen like this:

Infrastructure

if you have not set up

Disabled

tab and make sure that your wireless card

to close the wireless properties

icon and

Click here