Cisco 8821 Налаштування

Переглянути онлайн або завантажити pdf Налаштування для IP-телефон Cisco 8821. Cisco 8821 16 сторінок. Wireless ip phone
Також для Cisco 8821: Посібник з використання аксесуарів (30 сторінок), Усунення несправностей (5 сторінок), Посібник кінцевого користувача (6 сторінок), Посібник із швидкого старту (2 сторінок)

Phone Setup

•

Phone Hardware Installation

Before you can use your phone, you must install and charge the battery. The battery may already be installed

in your phone, or you may have to install it yourself.

You must read the safety information in

phone.

The battery may already be charged using one of the supported charging methods. If the battery isn't charged,

you must charge the battery before you can set up the phone.

Install the Cisco Wireless IP Phone 8821 Battery

IP54 compliance mean that the phone is sealed from dust and water. When the phone leaves the factory, it is

completely sealed.

If you need to open the battery compartment, don't open it in a dusty or wet environment.

You should make sure that the battery cover is closed to ensure that dust and water cannot enter the battery

compartment.

Note

Dirt, oil, or other products can damage the gasket on the battery compartment cover, resulting in a poor seal.

Every time you change the battery, inspect the gasket for damage. If the gasket is damaged, you can order a

replacement cover.

Phone Hardware Installation, on page 1

Phone Configuration Tasks, on page 15

Product Safety and Security

before you use, install, or charge the

Phone Setup