Ricoh G348 Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Аксесуари для принтерів Ricoh G348. Ricoh G348 4 сторінки. Service tables duplex unit
Також для Ricoh G348: Посібник з монтажу (4 сторінок)

Друкувати сторінку

Remove the protective cover on the left side of the printer.

Hold the protective cover by both sides, and while pushing

the left side of the cover ( ), open it in the direction of

the arrow ( ), and then remove ( ).

Note

You cannot use the removed protective cover.

Attach the paper guide to the stand. Hold it so that the

right side bends down as shown, and then while gripping

lightly ( ), insert it into the holes of the stand ( ).

Insert the claws of the stand into the holes on the left side

of the printer ( ), and then push down ( ).

Slowly open the front cover by pulling on the two areas on

the left and right.

ZDJP041J

ZDJP042J

ZDJP043J

ZDJH007J

Remove the green screwdriver, and then close the front

cover.

Use this screwdriver for all attachment and detachment of screws.

Note

After using the screwdriver, return it to its original position on

the inside of the front cover.

Tighten the four long screws fastening the duplex reversal

unit stand, using provided screwdriver. Fasten in the

c c , as shown.

order of

This completes the installation of the stand. Next, install the duplex reversal unit.

Installing the Duplex Reversal Unit

With both hands, hold the duplex reversal unit level, and

then insert the hooks into the groove of the stand. Adjust

the tip of the hooks to the line on the stand, as shown,

and then insert slowly. Do not let go of the duplex reversal

unit even after insertion.

The hooks of the duplex reversal unit clip around the bar inside the groove of the

stand.

ZHXH171J

ZDJP044J

ZHXH250J