Ricoh G348 Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з монтажу для Аксесуари для принтерів Ricoh G348. Ricoh G348 4 сторінки. Service tables duplex unit
Також для Ricoh G348: Посібник з монтажу (4 сторінок)
Друкувати сторінку
While supporting the duplex reversal unit, remove the
stopper of the printer's mounting bracket.
This stopper will be used in a later step
While supporting the duplex reversal unit, remove the
adhesive tape, and then hold the auxiliary bar in front of
the hook on the left side, and then stand it up.
Hook the hole of the auxiliary bar onto the printer's
mounting bracket.
In step
, move the auxiliary bar to the position with the perforated line, as
shown.
Hang the auxiliary bar on the far left end, as shown, and
then install the stopper removed in step
Make sure the auxiliary bar and stopper are installed in the positions, as shown.
ZDJP046J
, so take care not to lose it.
ZDJP047J
ZDJP048J
.
ZDJP049J
Slowly raise the duplex reversal unit, and then fold it up
to the printer.
Remove the adhesive tape holdings the cable, and then
connect the cable from the duplex reversal unit to the
upper connector on the back of the printer.
This completes installation of the duplex reversal unit. Install the duplex feed
unit after the external tray.
Install the external tray.
Stand the external tray, and then insert it from the
left side using both hands.
Pushing the right edge of the external tray
lightly with your finger (
ZDJP050J
ZHXH260J
ZHXH270J
), insert it (
).
ZDJP053J