ActronAir MGW-KNXCS Посібник з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Шлюз ActronAir MGW-KNXCS. ActronAir MGW-KNXCS 16 сторінок. Vrf knx gateway

Note to installation of MGW-KNXCS:

1. One KNX module can only connect with one indoor unit;The KNX module should

connect to indoor D1D2E ports.

2. Circuit of MGW-KNXCS is low voltage circuit. Never connect it with a standard

220V/380V circuit or put it into a same Wiring Tube with the circuit.

3. Do not attempt to extend the shield cable by cutting, if it is necessary, use

Terminal Connection Block to connect.

4. After finishing connection, do not use Megger to have the insulation check to the

signal wire.

5. The default physical address of the MGW-KNXCS is 15.15.255,If there are two or

more KNX modules, then the physical addresses can not repeat.The physical

address can be changed by ETS software.

6. Before installation,need prepare KNX power module .