Cisco WS-X45-SUP6-E - Supervisor Engine 6-E Примітка щодо встановлення та налаштування - Сторінка 22
Переглянути онлайн або завантажити pdf Примітка щодо встановлення та налаштування для Мережевий маршрутизатор Cisco WS-X45-SUP6-E - Supervisor Engine 6-E. Cisco WS-X45-SUP6-E - Supervisor Engine 6-E 30 сторінок.
Друкувати сторінку
Installing the 10-Gigabit Ethernet X2 Transceiver
Check the label on the 10-Gigabit Ethernet X2 transceiver to verify that the 10-Gigabit Ethernet X2
Step 3
transceiver is the correct model for your network.
Step 4
Grip the sides of the 10-Gigabit Ethernet X2 transceiver sleeve with your thumb and forefinger, and
insert the 10-Gigabit Ethernet X2 transceiver into the X2 socket on the module front panel. You will hear
a click when the X2 transceiver is approximately 90 percent installed. Continue sliding the X2
transceiver into the socket until you hear a second click. The X2 transceiver connector is now mated to
the socket connector. Verify that the X2 transceiver EMI gasket is in contact with the module faceplate.
(See
Figure
Tip
With some X2 transceivers you might need to pull out the latching sleeve as you slide the X2 transceiver
into the socket. When the EMI gasket makes contact with the module faceplate, slide the latching sleeve
in to secure the X2 transceiver in the socket.
Figure 8
Note
Remove the dust plugs from the network interface cable SC connectors.
Step 5
Save the dust plugs for future use.
Inspect and clean the SC connector's fiber-optic end-faces. Refer to the Tip below for a pointer to a
Step 6
fiber-optic inspection and cleaning white paper.
Installation and Configuration Note for the Catalyst 4500 E-Series Supervisor Engine 6-E
22
8.)
Installing the 10-Gigabit Ethernet X2 Transceiver
L I N
10-Gigabit Ethernet X2 transceivers are keyed to prevent incorrect insertion.
Port cover
1
K
A C
2
T I
V E
L I N
K
A C
T I
V E
78-18337-01