Cisco WS-X45-SUP6-E - Supervisor Engine 6-E Примітка щодо встановлення та налаштування - Сторінка 23
Переглянути онлайн або завантажити pdf Примітка щодо встановлення та налаштування для Мережевий маршрутизатор Cisco WS-X45-SUP6-E - Supervisor Engine 6-E. Cisco WS-X45-SUP6-E - Supervisor Engine 6-E 30 сторінок.
Друкувати сторінку
Tip
For complete information on inspecting and cleaning fiber-optic connections, refer to the white-paper
document at this URL:
http://www.cisco.com/en/US/tech/tk482/tk876/technologies_white_paper09186a0080254eba.shtml
Remove the dust plugs from the 10-Gigabit Ethernet X2 transceiver optical bores.
Step 7
Immediately attach the network interface cable SC connectors to the 10-Gigabit Ethernet X2 transceiver.
Step 8
Removing the 10-Gigabit Ethernet X2 Transceiver
The 10-Gigabit Ethernet X2 transceiver is a static-sensitive device. Always use an ESD wrist strap or
Caution
similar individual grounding device when handling X2 transceivers or coming into contact with
modules.
If you are removing a 10-Gigabit Ethernet X2 transceiver, follow these steps:
Disconnect the network fiber-optic cable from the 10-Gigabit Ethernet X2 transceiver connectors.
Step 1
Immediately reinstall the dust plugs in the X2 transceiver optical bores and the fiber-optic cable SC
connectors
Grip the sides of the 10-Gigabit Ethernet X2 transceiver sleeve with your thumb and forefinger, and pull
Step 2
the sleeve out to release the X2 transceiver from the socket connector. (See
Figure 9
Step 3
Slide the 10-Gigabit Ethernet X2 transceiver out of the socket and immediately place it in an antistatic
bag.
78-18337-01
Removing the 10-Gigabit Ethernet X2 Transceiver
1
L I N
K
A C
2
T I
V E
L I N
K
A C
T I
V E
Installation and Configuration Note for the Catalyst 4500 E-Series Supervisor Engine 6-E
Removing the 10-Gigabit Ethernet X2 Transceiver
Figure
9.)
23