Cisco WAP321 Посібник із швидкого старту - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Бездротова точка доступу Cisco WAP321. Cisco WAP321 13 сторінок. Reboot and reset to factory default settings
Також для Cisco WAP321: Огляд (6 сторінок), Технічний паспорт (8 сторінок), Брошура та технічні характеристики (4 сторінок), Посібник із швидкого старту (13 сторінок), Посібник (4 сторінок), Посібник (4 сторінок)

To mount the WAP device to a wall or ceiling:

Determine where you want to mount the device. Verify that the

TEP

surface is smooth, flat, dry, and sturdy.

Drill two pilot holes into the surface 1.85 inches (47 mm) apart for

TEP

the Cisco WAP121. For the WAP321, drill the holes 2.75 inches

(70 mm) apart.

Insert a screw into each hole, leaving a gap between the surface

TEP

and the base of the screw head.

Place the upper slots of the bracket over the screws, adjust the

TEP

screws accordingly, and slide the bracket down until the screws fit

snugly into the slots.

Using the bracket as a template, drill two more holes for the lower

TEP

screws.

Insert a screw into each lower hole.

TEP

Slide the WAP device into the bracket, placing the cables or cords

TEP

through the break-out tab found in the back of the bracket.

Connecting the Cisco WAP121 and

WAP321 Wireless-N Access Points

To connect the device to the network:

Connect the Ethernet cable to the Ethernet port of a switch or a

TEP

router.

Connect the other end of the network Ethernet cable to the

TEP

Ethernet port of the wireless access point.

If PoE is not provided, for the Cisco WAP121 plug in the power

TEP

adaptor to provide power to the device. For the Cisco WAP321, the

power adaptor is sold separately.

After installation, all lights should be active. Refer to

Hardware Installation, page 6

switch.

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE

for details about the different lights on each

Verifying the