Cisco Profile Series Посібник - Сторінка 9

Друкувати сторінку

1. Configuring Switches

Get To Know Your Switch

Step 2

Connect the computer to any network port.

Note

For Cisco 350-550 XG switches, connect the computer to the OOB port found on the front panel.

Step 3

Set up the IP configuration on your computer.

a) If the switch is using the default static IP address of 192.168.1.254/24, you must choose an IP address for the computer

in the range of 192.168.1.2 to 192.168.1.253 that is not already in use.

b) If the IP addresses will be assigned by DHCP, make sure that your DHCP server is running and can be reached from

the switch and the computer. You may need to disconnect and reconnect the devices for them to discover their new

IP addresses from the DHCP server.

Note

Details on how to change the IP address on your computer depend upon the type of architecture and operating

system that you are using. Use your computers local Help and Support functionality and search for "IP

Addressing."

Step 4

Open a web browser window.

Step 5

Enter the switch IP address in the address bar and press Enter. For example, http://192.168.1.254.

Step 6

When the login page appears, choose the language that you prefer to use in the web-based interface and enter the username

and password.

The default username is cisco. The default password is cisco. Usernames and passwords are both case sensitive.

Step 7

Click Log In.

If this is the first time that you have logged on with the default username and password, the Change username and Password

page opens. The rules for constructing a new password are displayed on the page.

Step 8

Enter a new username and password and confirm.

Note

Password complexity is enabled by default. The password must comply with the default complexity rules.

Step 9

Click Apply.

Caution

Make sure that any configuration changes made are saved before exiting from the web-based interface by

clicking on the Save icon. Exiting before you save your configuration results in all changes being lost.

The Getting Started page opens. You are now ready to configure the switch. Refer to the Administration Guide or see

the help pages for further information.

Browser Restrictions

If you are using IPv6 interfaces on your management station, use the IPv6 global address and not the IPv6

link local address to access the device from your browser.

Configuring Your Switch Using the Console Port

To configure the switch using the console port, proceed with the following steps:

Step 1

Connect a computer to the switch console port using a Cisco console cable (purchased separately).

Step 2

Start a console port utility such as HyperTerminal on the computer.

Configuring Your Switch Using the Console Port

Get To Know Your Switch