Cisco Profile Series Посібник - Сторінка 7

Get To Know Your Switch

• 60-Watt PoE Ports—Highlighted in yellow. The 60-Watt PoE ports double the PoE power to 60W. This

• SFP+ Port (if present)—The small form-factor pluggable plus (SFP+) are connection points for modules

• Some SFP interfaces are shared with one other RJ-45 port, called a combo port. When the SFP is active,

• OOB Port (if present)—The Out of Band (OOB) port is a CPU Ethernet port that can be used only as a

Front Panel LEDs

The following are the global LEDs found on the devices:

• System—(Green) The LED lights steady when the switch is powered on, and flashes when booting,

• System LED - Every 20 seconds, the System LED will flash according to unit ID of the member unit.

is not found on the 250 devices nor on the SF350-48P device.

so that the switch can link to other switches. These ports are also commonly referred to as mini 10GigaBit

Interface Converter ports. The term SFP+ is used in this guide.

• The SFP+ ports are compatible with the following Cisco SFP 1G optical modules MGBSX1,

MGBLH1, MGBT1, as well as other brands.

• The Cisco SFP+ 10G optical modules that are supported in the Cisco switches are: SFP-10G-SR,

SFP-10G-LR, SFP-10G-SR-S, and SFP-10G-LR-S.

• The Cisco SFP+ Copper Cable modules that are supported in the Cisco switches are:

SFP-H10GB-CU1M, SFP-H10GB-CU3M, and SFP-H10GB-CU5M.

• The SFP+ port is a combination port, shared with one other RJ-45 port. When the SFP+ is active,

the adjacent RJ-45 port is disabled.

• The LEDs of the corresponding RJ-45 port flash green to respond to the SFP interface traffic.

the adjacent RJ-45 port is disabled.

management interface. Bridging between the OOB port and the in-band Layer 2 interface is not supported.

This does not appear on 250 devices.

performing self-tests, or acquiring an IP address. If the LED flashes Amber, the switch has detected a

hardware failure, a firmware failure, and/or a configuration file error.

• Flash = LED going off and then on again.

• According to unit ID of the unit. This means

• Unit 1 (if not active unit) - system LED will flash 1 time

• Unit 2 (if not active unit) - system LED will flash 2 times

• Unit 3 - system LED will flash 3 times

• Unit 4 -system LED will flash 4 times;

• The duration of each flash (LED off time) will be as follows:

• LED off time (in each flash) ~ 0.5 seconds.

• "Interim" LED on (between 2 LED offs) ~ 0.5 seconds

Front Panel LEDs

Get To Know Your Switch