Cisco TelePresence IX5200 Перше налаштування - Сторінка 17

Переглянути онлайн або завантажити pdf Перше налаштування для Конференц-система Cisco TelePresence IX5200. Cisco TelePresence IX5200 40 сторінок.
Також для Cisco TelePresence IX5200: Посібник користувача "Швидкий старт (15 сторінок), Посібник користувача (26 сторінок), Посібник з монтажу (36 сторінок)

Click the correct auxiliary display layout, then click Done.

Tip

If you clicked Yes in error and your system does not have auxiliary displays, click Cancel and continue

to the next step.

If the graphic shows the correct position of the displays, click Continue. If not, click Exit Setup,

power down your system, and check the cabling for your system.

Make sure that any auxiliary displays are correctly cabled as follows:

–

For more information, see the "Cable Routing Diagrams" section in the

and IX5200 Installation

OL-27038-01

If a single auxiliary display is present, connect it to the H5 port.

If two auxiliary displays are present, connect the left display to the H4 port and the right display

to the H6 port. The H5 port should remain unused.

If three auxiliary displays are present, connect the left display to the H4 port, the center display

to the H5 port, and the right display to the H6 port.

Guide.

Cisco TelePresence IX5000 and IX5200 First-Time Setup

Performing First-Time Setup

Cisco TelePresence IX5000