Cisco 3020 - Cisco Catalyst Blade Switch Посібник для початківців - Сторінка 22

Переглянути онлайн або завантажити pdf Посібник для початківців для Мережеве обладнання Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 37 сторінок. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Також для Cisco 3020 - Cisco Catalyst Blade Switch: Посібник для початківців (31 сторінок), Quickspecs (12 сторінок), Примітка до випуску (41 сторінок), Примітка до випуску (27 сторінок), Примітка до випуску (23 сторінок), Примітка до випуску (21 сторінок), Посібник з монтажу (21 сторінок)

Troubleshooting Express Setup

If Express Setup does not run, or if the Express Setup page does not appear in your browser:

• Did you verify that POST successfully ran

before starting Express Setup?

• Did you press the Mode button while the

switch module was still running POST?

• Did the switch module not power up?

• Did you try to continue without confirming

that the switch module was in Express Setup

mode?

• Does your PC have a static IP address?

• Did you connect a crossover cable instead of

a straight-through Ethernet cable between a

switch module port and the Ethernet port of

the PC?

• Did you connect the Ethernet cable to the

console port instead of to an Ethernet port

on the switch module?

If not, make sure that only the SYST and STAT

LEDs are green before pressing the Mode button

to enter the Express Setup mode.

If yes, wait until POST completes. Power cycle the

switch module. Wait until POST completes.

Confirm that the SYST and STAT LEDs are green.

Press the Mode button to enter Express Setup

mode.

The switch module is controlled by the Onboard

Administrator. If the switch module does not

power up, see the blade server documentation for

more information.

Verify that all LEDs next to the Mode button are

green. If necessary, press the Mode button to

enter Express Setup mode.

If yes, before connecting to the switch module,

change your PC settings to temporarily use

DHCP.

If yes, connect a straight-through cable to an

Ethernet port on the switch module and the PC.

Wait 30 seconds before you enter 10.0.0.1 in the

browser.

If yes, disconnect the cable from the console port.

Then connect the cable to an Ethernet port on the

switch module and the PC. Wait 30 seconds

before you enter 10.0.0.1 in the browser.