Cisco Aironet 340 Series Посібник із швидкого старту - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання Cisco Aironet 340 Series. Cisco Aironet 340 Series 13 сторінок. Usb client adapter
Також для Cisco Aironet 340 Series: Посібник із швидкого старту (12 сторінок), Примітки до випуску (14 сторінок), Посібник із швидкого старту (16 сторінок), Посібник із швидкого старту (12 сторінок), Посібник із швидкого старту (12 сторінок)

Double-click the BSCU folder to display it.

Double-click the setup.exe file. The installation wizard appears.

Follow the steps provided by the installation wizard.

When requested by the installation wizard, select Talk To A Base Station To Access The

Internet.

Select the Launch Base Station Client Utility check box and click Finish to start the utility.

A pop-up window appears reminding you that your SSID and WEP Encryption Key are

currently set to the default values. See the following section to change the SSID and WEP

Encryption Key from their default values.

Configuring a Radio Card

A wireless PC must be configured to communicate with the base station before initial

configuration of the base station can be accomplished. You can configure a PC with a radio

card by using the BSCU or another vendor's IEEE 802.11 DSSS radio card. If you are using

another vendor's radio card, see the Cisco Aironet 340 Series Base Station Hardware

Installation Guide.

Follow these steps to configure the PC and radio card using the BSCU:

Select Start > Settings > Control Panel > Network > Protocols > TCP/IP (for the Cisco

Aironet wireless LAN adapters) > Properties to display the TCP/IP Properties window.

Refer to the Cisco Aironet 340 Series Base Station Software Configuration Guide if you

need further assistance.

Click the Obtain an IP address from the DHCP server radio button.

Double-click the BSCU icon on the PC desktop to activate the utility.

Note

A warning message might be displayed that indicates the SSID and radio network

encryption are set to default values. Click OK.