Cisco ASR 9910 Посібник - Сторінка 27
Переглянути онлайн або завантажити pdf Посібник для Мережеве обладнання Cisco ASR 9910. Cisco ASR 9910 44 сторінки. Replacing cisco asr 9000 series router components
Друкувати сторінку- 1. Field Replaceable Units
- 2. Online Insertion and Removal
- 3. Powering off the Router
- 4. Replacing the Chassis Air Filter
- 5. Required Tools and Equipment
- 6. Removing a Fan Tray
- 7. Installing a Fan Tray
- 8. Disconnecting AC Power
- 9. Reconnecting AC Power
- 10. Disconnecting DC Power
- 11. Reconnecting DC Power
Replacing Cisco ASR 9000 Series Router Components
Caution
Replacing Cards in the Chassis
Follow these steps to replace a previously removed RSP card, RP card, FC, or LC from the card cage:
Procedure
Step 1
Install the card:
a) Slide the card into the slot, being sure to install the card in the same slot you recorded when you removed
the card.
b) Use the 6-inch long number 2 Phillips screwdriver to a torque of 10 +/–1 in-lb to tighten the captive screws
at each end of the card front panel.
c) Pivot the ejector levers to seat the card into the backplane connector.
Step 2
Reconnect cables to the card:
a) If you previously disconnected the card cable management bracket, reattach it to the card and use the
6-inch long number 2 Phillips screwdriver to a torque of 10 +/–1 in-lb to tighten the captive screw on the
bracket to secure it to the card front panel.
b) Carefully reroute the cables through the horizontal cable management tray at the top of the chassis (the
Cisco ASR 9922 Router has an additional tray at the bottom of the chassis) or side cable management
brackets (Cisco ASR 9006 Router and Cisco ASR 9904 Router).
c) Carefully reroute cables through the card cable-management bracket.
d) Starting with the port of the card closest to the cable management bracket, reconnect the interface cable
connectors to each of the card ports using the cable and port connection information you recorded when
removing the cables.
Step 3
If the card was powered down using CLI before removal, then power up the card using the CLI:
Router# admin
Router(admin)# config
Router(admin-config)# no hw-module power disable location location
Router(admin-config)# commit
Router(admin-config)# exit
The location is specified in rack/slot/cpu notation. For example, no hw-module power disable location
0/1/CPU0.
Migrating from RP1 to RP2 Card
Before you begin:
• You must have console access to the router.
A line card surface temperature may exceed 55 °C during normal operation. To avoid burn
injuries, please take necessary precautions while removing the heated card from the chassis.
Replacing Cisco ASR 9000 Series Router Components
Replacing Cards in the Chassis
27