Digitrax DN166I2B Інструкція з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка Digitrax DN166I2B. Digitrax DN166I2B 8 сторінок.

Installation Notes

Do not exceed the decoder's

500mA total function output

rating.

We recommend that the Blue

wire, also called +Common or

Lamp Common, be connected

as shown. If you wish to omit

the Blue wire in your instal-

lation, consult the Digitrax

Decoder Manual for more

information.

The head lamp should

be hooked up using the

Blue/+Common wire for

optimal Digitrax transponding

operation.

To use a function output with

an inductive (coil) type load, see

the Digitrax Decoder Manual

for more information to avoid

damage to the decoder.

See the Digitrax Decoder Man-

ual for full details of wiring 12-16V lamps, 1.5V lamps, and LEDs. Lamps that

draw more than 80 mA when running require a 22 ohm 1/4 watt resistor in

series with the directional light function lead to protect the decoder.

Some locomotives employ filter capacitors for RFI suppression in the loco-

motive wiring. These may cause problems with Supersonic decoders and

non-decoder analog operation on DCC. This capacitor should be removed for

safe operation.

Customizing Your Decoder

Your Digitrax decoder is ready to run and will operate using address 03 with no

additional programming. For a more prototypical railroading experience, your

decoder can be customized for your specific locomotive by programming some of

the Configuration Variables, or CVs, available. See the Digitrax Decoder Manual

or the Digitrax web site for more information.

Figure 3: Wires unsoldered from

light board.

Figure 4: Wires soldered onto

the DN166I2B

— 3 —

Wires soldered on.