Digitroll DMS 06 Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Системи управління Digitroll DMS 06. Digitroll DMS 06 12 сторінок. Planter monitor

Друкувати сторінку

INSTALLATION

MONITOR LOCATION
The monitor has to be mounted in the compartment at a well visible place with
the attaching clip being in lower or upper position using 2 plate screws. Avoid
direct sunlight to reach the display. The most favourable location for the
monitor is right under the compartment roof.
•
The monitor is to be connected to the 12V system of the power machine
behind a minimum 1A fuse with regard to polarity (red = positive, blue =
negative). The wire between the connection point and the 12V
accumulator of the power machine should be as short as possible.
•
Connect the sensors' extension cable to the monitor.
•
Do not share power supply with devices that may cause interference (fans,
magnetic valves, etc.).
•
Welding works are only allowed when both power cables of the monitor
are disconnected from the tractor's electronic system.

CONTROL DEVICE

Stand-by signal
(red light)
ON and TEST button
(searching seed
sensors, checking
dust level)
Horn
IN TELLIGENT SENSOR TECHNOLOGY
S tring C ircuitry
0,25
0,5
0,75
1
2
3
TEST
DIGITROLL
DMS 06 PLANTER MONITOR
Switched on, 12V OUT= continuous light
Sensor search
= darkens for a short time
Cable short
= dark during operation
Switched off
= dark
1
1,5
2
sec
4
5
6 ROWS
OUT
AUTO OFF
INSTALLATION
Selectable time
intervals (0.25 – 2 sec)
error = red light
Number of seeder
elements (1-6)
Adjusting sensitivity of
error indication
(max. time period of
seed shortfall)
5