Cisco SCE8000 GBE Процедури зняття та заміни - Сторінка 4

Переглянути онлайн або завантажити pdf Процедури зняття та заміни для Мережеве обладнання Cisco SCE8000 GBE. Cisco SCE8000 GBE 36 сторінок. 10gbe platform
Також для Cisco SCE8000 GBE: Посібник із швидкого старту (25 сторінок), Посібник з конфігурації (18 сторінок), Встановлення (21 сторінок)

Removing and Replacing the Power Supply

This section describes how to remove and install power supplies for the Cisco SCE 8000.

In systems with redundant power supplies, you can replace the faulty supply while the system is

Note

operating.

This section contains the following information:

•

Required Tools

A flat-blade or number 2 Phillips-head screwdriver is required to perform these procedures.

Additionally, a wire cutter or scissors may be necessary for cutting cable tie-wraps.

Removing an AC-Input Power Supply

Warning

Hazardous voltage or energy is present on the backplane when the system is operating. Use caution

when servicing.

Statement 1034

Turn the power switch to the Off (0) position on the power supply you are removing.

Step 1

Disconnect the power cord from the power source. Do not touch the metal prongs on the power cord

Step 2

when it is still connected to the power supply.

Remove the power cord from the power connection on the power supply module. Do not touch the metal

Step 3

prongs embedded in the power supply.

Cisco SCE8000 10GBE Installation and Configuration Guide

9-4

Required Tools, page 9-4

Removing an AC-Input Power Supply, page 9-4

Installing an AC-Input Power Supply, page 9-6

Removing a DC-Input Power Supply, page 9-6

Installing a DC-Input Power Supply, page 9-8

Chapter 9 Removal and Replacement Procedures

OL-26784-02