Cisco TelePresence Server 7010 Інструкція із заміни Посібник із заміни - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція із заміни Посібник із заміни для Мережеве обладнання Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 23 сторінки. 600w ac-input power supply and fan tray replacement
Також для Cisco TelePresence Server 7010: Інструкція з монтажу Посібник з монтажу (15 сторінок), Посібник з монтажу (14 сторінок), Початок роботи (16 сторінок), Інструкція із заміни Посібник із заміни (18 сторінок)

Replacing the Chassis

Figure 6

Installing the Cable Management Brackets

The cable management brackets help to keep network interface cables untangled and orderly, and

prevent cables from hindering access to interface processors in the lower interface processor slots.

The brackets attach to the inner sides of the chassis at the interface processor end. Six M3 x 8-mm,

Phillips panhead screws, which are included with the brackets, secure the brackets to the chassis

(three per bracket). Figure 7 shows the interface processor end of the chassis with the brackets

installed.

Note

referred to as the chassis.

Install the brackets on the new chassis ﬁrst, before you begin moving system components from the

old chassis. If you install the brackets after you move the interface processors and connect the

interface cables, you might have to disconnect the cables to install the screws that secure the

brackets. Route interface cables through the cable management brackets as you connect them to the

interface processor ports (or as you install interface processors that still have interface cables

connected to them). Wrap cable ties through the holes provided to secure small-gauge cables.

12 Cisco 7010 and Cisco 7505 Chassis Replacement Instructions

Installing the Chassis in a Standard Four-Post, 19-Inch Equipment Rack

Chassis front

For this procedure, the Cisco 7010 and Cisco 7505 chassis are functionally the same, and are