Cisco S695F Посібник з встановлення обладнання - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник з встановлення обладнання для Сервер Cisco S695F. Cisco S695F 50 сторінок. Web security appliance
Також для Cisco S695F: Посібник для початківців (18 сторінок), Посібник (24 сторінок)
Друкувати сторінку
Rear Panel
Figure 12: S695F Rear Panel
1
Traffic monitor port 1 (T1)
Use for Duplex Ethernet tap; one cable for all
incoming and outgoing traffic.
1/10-Gigabit Ethernet SFP+ support
Note
Note
3
Proxy port 1 (P1)
Connects to the network for both incoming and
outgoing traffic.
1/10-Gigabit Ethernet SFP+ support
Note
Note
5
1050-W AC power supply (PSU 1)
Cisco Web Security Appliance S195, S395, S695, and S695F Hardware Installation Guide
14
The GLX-SX-MMD (1 Gb) and
SFP-10G-SR (10 Gb) are the only
SFP+ transceivers qualified by Cisco.
Use only Cisco-qualified SFPs.
Copper SFPs are not supported.
The GLX-SX-MMD (1 Gb) and
SFP-10G-SR (10 Gb) are the only
SFP+ transceivers qualified by Cisco.
Use only Cisco-qualified SFPs.
Copper SFPs are not supported.
2
Traffic monitor port 2 (T2)
Use for Simplex Ethernet tap; one cable connected
to T1 for all packets going to the internet. and one
cable connected to T2 for all packets coming from
the internet.
1/10-Gigabit Ethernet SFP+ support
Note
The GLX-SX-MMD (1 Gb) and
SFP-10G-SR (10 Gb) are the only
SFP+ transceivers qualified by Cisco.
Use only Cisco-qualified SFPs.
Note
Copper SFPs are not supported.
4
Proxy port 2 (P2)
When P1 and P2 are both enabled, you must
connect P1 to the internal network and P2 to the
internet.
You can connect P1 and P2 to an L4
Note
switch, WCCP router, or network
switch.
1/10-Gigabit Ethernet SFP+ support
Note
The GLX-SX-MMD (1 Gb) and
SFP-10G-SR (10 Gb) are the only
SFP+ transceivers qualified by Cisco.
Use only Cisco-qualified SFPs.
Note
Copper SFPs are not supported.
6
1050-W AC power supply (PSU 2)
Overview