Cisco S695F 하드웨어 설치 매뉴얼 - 페이지 18

{카테고리_이름} Cisco S695F에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco S695F 50 페이지. Web security appliance
Cisco S695F에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (18 페이지), 매뉴얼 (24 페이지)

페이지 인쇄

Rear Panel

Figure 12: S695F Rear Panel

Traffic monitor port 1 (T1)

Use for Duplex Ethernet tap; one cable for all

incoming and outgoing traffic.

1/10-Gigabit Ethernet SFP+ support

Note

Proxy port 1 (P1)

Connects to the network for both incoming and

outgoing traffic.

1/10-Gigabit Ethernet SFP+ support

Note

1050-W AC power supply (PSU 1)

Cisco Web Security Appliance S195, S395, S695, and S695F Hardware Installation Guide

The GLX-SX-MMD (1 Gb) and

SFP-10G-SR (10 Gb) are the only

SFP+ transceivers qualified by Cisco.

Use only Cisco-qualified SFPs.

Copper SFPs are not supported.

The GLX-SX-MMD (1 Gb) and

SFP-10G-SR (10 Gb) are the only

SFP+ transceivers qualified by Cisco.

Use only Cisco-qualified SFPs.

Copper SFPs are not supported.

Traffic monitor port 2 (T2)

Use for Simplex Ethernet tap; one cable connected

to T1 for all packets going to the internet. and one

cable connected to T2 for all packets coming from

the internet.

1/10-Gigabit Ethernet SFP+ support

Note

The GLX-SX-MMD (1 Gb) and

SFP-10G-SR (10 Gb) are the only

SFP+ transceivers qualified by Cisco.

Use only Cisco-qualified SFPs.

Note

Copper SFPs are not supported.

Proxy port 2 (P2)

When P1 and P2 are both enabled, you must

connect P1 to the internal network and P2 to the

internet.

You can connect P1 and P2 to an L4

Note

switch, WCCP router, or network

switch.

1/10-Gigabit Ethernet SFP+ support

Note

The GLX-SX-MMD (1 Gb) and

SFP-10G-SR (10 Gb) are the only

SFP+ transceivers qualified by Cisco.

Use only Cisco-qualified SFPs.

Note

Copper SFPs are not supported.

1050-W AC power supply (PSU 2)

Overview