Cisco TelePresence Посібник адміністратора - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник адміністратора для Сервер Cisco TelePresence. Cisco TelePresence 27 сторінок. Configuring a cisco unified communications manager sip trunk with a cisco telepresence content server
Також для Cisco TelePresence: Брошура (4 сторінок), Технічні характеристики (7 сторінок), Посібник з монтажу (4 сторінок), Короткий довідник (2 сторінок), Посібник (24 сторінок), Інструкція з монтажу (2 сторінок)

Cisco TelePresence ISDN Link

Contents

Introduction

The unit can be configured through the serial port or over the network.

Connect to the ISDN Link through the serial port

1. Use a standard serial cable and connect the cable between ISDN Link serial port and PC/laptop.

2. Use a terminal program to connect to the ISDN Link (115200, 8, 1, none)

3. Login as admin.

Connect to the ISDN Link over the network

When you know the IP Address of your ISDN Link unit an SSH over IP connection can be

established.

In order to find the IP address this is best done by using the serial port (See "Connect to the ISDN

Link through the serial port" on page 10above) and run the following command: xStatus

Network

1. Connect the network cable between ISDN Link Ethernet port and LAN network.

2. Use a PC/laptop connected to the same LAN network and open a command line interface, e.g.

PuTTY. Enter the IP Address and select Connection Type SSH.

3. Login as admin.

D14954.01

ISDN Link Administrator Guide IL1.0, June 2012.

Getting started

Configuration examples

Troubleshooting

Whenever the PWR LED turns red, it is an indication of something wrong, most likely causing

problems for normal use.

Checking the system unit status

Use the following command to get some basic indication of the problem:

In case of multiple errors, only the error with the highest priority is shown, and must be solved

before lower priority error is shown.

Password protection

xStatus SystemUnit State Status

Administrator guide

Appendices