Cisco UCS B460 M4 Вказівки щодо встановлення та обслуговування - Сторінка 41

Переглянути онлайн або завантажити pdf Вказівки щодо встановлення та обслуговування для Сервер Cisco UCS B460 M4. Cisco UCS B460 M4 50 сторінок. Blade server
Також для Cisco UCS B460 M4: Технічний паспорт (7 сторінок), Вказівки щодо встановлення та обслуговування (46 сторінок), Посібник із швидкого старту (2 сторінок), Посібник із швидкого старту (5 сторінок)

Servicing the Blade Server

Procedure

Step 1

Position the VIC board connector above the motherboard connector and align the captive screw to the standoff

post on the motherboard.

Step 2

Firmly press the VIC board connector into the motherboard connector.

Step 3

Tighten the captive screw.

Tip

Figure 19: Installing a VIC mLOM Adapter

Installing an Adapter Card

All the supported mezzanine cards have a common installation process. These cards are updated frequently.

Currently supported cards and the available models for this server are listed in the specification sheets at this

URL:

http://www.cisco.com/c/en/us/products/servers-unified-computing/ucs-b-series-blade-servers/datasheet-listing.html

If you are switching from one type of adapter card to another, before you physically perform the switch make

sure that you download the latest device drivers and load them into the server's operating system. For more

information, see the firmware management chapter of one of the Cisco UCS Manager software configuration

guides.

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v3 and E7 v2 CPUs

To remove a VIC, reverse the above procedure. You might find it helpful when removing the

connector from the motherboard to gently rock the board along the length of the connector until it

loosens.