Cisco ASR 5000 Посібник з монтажу - Сторінка 23

Переглянути онлайн або завантажити pdf Посібник з монтажу для Шлюз Cisco ASR 5000. Cisco ASR 5000 33 сторінки. Applying power and verifying the installation
Також для Cisco ASR 5000: Посібник з монтажу (18 сторінок), Процедура встановлення (8 сторінок), Посібник з монтажу (37 сторінок)

Друкувати сторінку

Troubleshooting

In the event that an issue arises that is not severe enough for the system to perform an automatic migration,

a manual migration can be invoked. Follow the instructions below to manually initiate a packet processing

card migration. These instructions assume you are at the root prompt for the Exec mode.

Step 1

Initiate a manual packet processing card migration by entering the following command:

host_name

[local]

You will receive the following prompt:

Are You Sure? [Yes|No]:

For a complete description of the above command, see the Exec Mode Commands chapter of the Command line Interface

Reference.

Step 2

Press Y to start the migration.

Step 3

Verify that the migration was successful by entering the following command.

host_name

[local]

Check the entry in the Oper State column next to the packet processing card that was just migrated from. Its state should

be Standby. The state of the packet processing card migrated to should be Active.

Manually Initiating a Line Card or SPIO Switchover

Ethernet line cards are installed in the half-height slots at the rear of the chassis. This design allows for two

half-height line cards to be installed behind every application card (vertical redundancy). With two line cards

installed, booting their associated application card causes the card in the upper-rear chassis slot to automatically

be made active while the card in the lower-rear chassis slot will automatically be placed in standby mode. In

the event that the active card experiences a failure, the system will automatically switch traffic to the standby

card in the lower slot.

The XGLC is a full-height card that supports 1:1 side-by-side redundancy. Side-by-side (horizontal) redundancy

allows two XGLC cards installed in neighboring slots to act as a redundant pair. Side-by-side pair slots for

the XGLC are: 17-18, 19-20, 21-22, 23-26, 27-28, 29-30, and 31-32. If the XGLCs are not configured for

side-by-side redundancy, they run independently without redundancy.

When configured for side-by-side redundancy, The XGLC is referenced only by the upper slot number (17

through 23, 26 through 33); the lower slot number is not recognized. All other configuration commands work

as if the side-by-side slots were top-bottom slots. Configuration commands directed at the bottom slots either

fail with errors or are disallowed.

In the event that a SPIO experiences a failure, the system will automatically switch traffic to the redundant

SPIO installed behind the redundant SMC.

In the event that an issue arises that is not severe enough for the system to perform an automatic switchover,

a manual switchover can be performed. Follow the instructions below to manually initiate a line card or SPIO

switchover. These instructions assume you are at the root prompt for the Exec mode:.

Step 1

Initiate a manual line card or SPIO migration by entering the following command:

host_name

[local]

card migrate from original_slot# to final_slot#

show card table

card switch from slot# to slot#

Manually Initiating a Line Card or SPIO Switchover

ASR 5000 System Administration Guide, StarOS Release 21.2