Acuity Brands Lithonia Lighting XVML Інструкція з монтажу Посібник з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Світильник Acuity Brands Lithonia Lighting XVML. Acuity Brands Lithonia Lighting XVML 8 сторінок.
Друкувати сторінку
8. To suspend fi xture, secure chain (not supplied) to fi xture wire
support arms. (Chain must be suitable to support four times
fi xture weight).
WIRING AND FIXTURE OPERATION
CAUTION: Connect fi xture to supply wires rated for at
least 90°C (194°F).
NOTE: Waterproof conduit required for use with supplied
watertight fi tting-
XVML 3500LM (3/8"), XVML 5000LM (1/2")
9. Remove large nut and components from Liquid Tight fi tting (5).
10. Insert the locknut onto the watertight conduit.- See Fig 5
11. Insert the sealing ring onto the conduit with the tapered end
toward the end of the conduit. Insert the metal cone into the end
of the conduit. See Fig 5
12. Feed incoming power cord though conduit into fi xture. Make sure
enough wire is fed into fi xture to reach center of fi xture.
13. Insert conduit assembly into fi tting installed on end of fi xture.
Securely tighten locknut onto fi tting. See Fig 6
14. Make wire connections by connecting bare copper or green
supply wire to both green fi xture wires with wirenut (8). Connect
black supply wire to black fi xture wire and white supply wire to
white fi xture wire with wirenut.
For proper connection- place wirenut over wires, twist clock-
wise until tight.
For Fixture with 0-10V dimming (120 - 277V driver
only), use Wirenuts to connect violet dimmer wire
from fi xture (+) to positive (+) wire from dimmer and
gray dimmer wire ( - ) from fi xture to negative ( - ) wire
from dimmer.
15. Bundle wires together and position inside wire way.
16. Position wireway cover (3) onto fi xture opening making sure
wires are not pinched between housing and cover. Rotate latches
(7) to secure to housing.
17. To install Diffuser (2)- Place Diffuser edge onto gasket area on
the perimeter of housing. Hook Latch under lip of Diffuser and
press inward on latch body to secure.
18. Installation is complete. Turn on electricity at fuse or circuit
breaker box.
Sealing Ring
Page 6
Locknut
Metal Cone
Figure 5
Figure 6