Epson DLQ-3500 Короткий посібник - Сторінка 14
Переглянути онлайн або завантажити pdf Короткий посібник для Аксесуари для принтерів Epson DLQ-3500. Epson DLQ-3500 32 сторінки. Epson serial impact dot matrix printers
Також для Epson DLQ-3500: Посібник з налаштування (31 сторінок), Повідомлення (1 сторінок), Довідковий посібник (34 сторінок)
Друкувати сторінкуSingle Sheets with the Paper Guide
Follow these steps to load single sheets from
the paper guide.
1. Make sure the paper guide is attached as
described in the Setup Guide. Then close
the tractor unit sprocket covers located
on the back of your printer and push
down the sprocket lock levers to lock the
sprockets in place.
2. Turn on the printer.
3. Make sure that Manual/CSF is selected
as the paper source on the control panel.
If not, select it by pressing the Paper
Source button.
4. Slide the edge guide until it rests against
the guide mark.
* guide mark
Off
Paper Source
Pau
al Paper
Tractor
ff
pe
Manual/CSF
3s
LF/F
EPSON DLQ-3500 Quick Guide
5. While aligning the left side of a sheet of
paper with the edge guide, insert it into
the printer until it meets resistance. Be
sure to load paper printable side up.
After a few seconds, the printer
automatically advances the paper to the
loading position. The printer is ready to start
printing.
c
Caution:
❏ Use the knob on the right side of the
printer only to clear paper jams when
the printer is off. Otherwise, you may
damage the printer or cause it to lose
the top-of-form position.
❏ Do not open the printer cover while
paper is being fed; otherwise the
printer cannot load the paper
correctly.
Note:
❏ If the platen rotates but the printer does not
load the paper, completely remove the paper
and then insert it all the way into the printer
again.
❏ If the paper feeds before you can adjust its
position properly, increase the Manual
feed wait time in the default-setting
mode. See "Changing default settings" for
more information.
Single Sheets with the Paper Guide (1/2)