Epson DLQ-3500 빠른 매뉴얼 - 페이지 14

{카테고리_이름} Epson DLQ-3500에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson DLQ-3500 32 페이지. Epson serial impact dot matrix printers
Epson DLQ-3500에 대해서도 마찬가지입니다: 설정 매뉴얼 (31 페이지), 공지 사항 (1 페이지), 참조 매뉴얼 (34 페이지)

페이지 인쇄

Single Sheets with the Paper Guide

Follow these steps to load single sheets from

the paper guide.

1. Make sure the paper guide is attached as

described in the Setup Guide. Then close

the tractor unit sprocket covers located

on the back of your printer and push

down the sprocket lock levers to lock the

sprockets in place.

2. Turn on the printer.

3. Make sure that Manual/CSF is selected

as the paper source on the control panel.

If not, select it by pressing the Paper

Source button.

4. Slide the edge guide until it rests against

the guide mark.

* guide mark

Off

Paper Source

Pau

al Paper

Tractor

Manual/CSF

LF/F

EPSON DLQ-3500 Quick Guide

5. While aligning the left side of a sheet of

paper with the edge guide, insert it into

the printer until it meets resistance. Be

sure to load paper printable side up.

After a few seconds, the printer

automatically advances the paper to the

loading position. The printer is ready to start

printing.

Caution:

❏ Use the knob on the right side of the

printer only to clear paper jams when

the printer is off. Otherwise, you may

damage the printer or cause it to lose

the top-of-form position.

❏ Do not open the printer cover while

paper is being fed; otherwise the

printer cannot load the paper

correctly.

Note:

❏ If the platen rotates but the printer does not

load the paper, completely remove the paper

and then insert it all the way into the printer

again.

❏ If the paper feeds before you can adjust its

position properly, increase the Manual

feed wait time in the default-setting

mode. See "Changing default settings" for

more information.

Single Sheets with the Paper Guide (1/2)