Acuity Brands Lighting KAX LED Інструкція з монтажу - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Освітлювальне обладнання Acuity Brands Lighting KAX LED. Acuity Brands Lighting KAX LED 5 сторінок.
Друкувати сторінкуInstallation Instructions
KAX LED
4. Insert the wires through the hole of the key hole slot and
pull them into the pole.
The luminaire is supplied with a clearance slot in the back to
allow wires to be pulled into the pole on existing hole patterns.
5. Thread the second bolt into the bottom threaded hole of
the bar stock plate.
Making sure that no wire are pinched, tighten the two bolts
with a 9/16 socket with to 20-30 ft-lbs (overtightening can
damage components and void warranties).
Make sure that wires are not pinched and tuck excess wire up
into the luminaire mounting area.
Reinstall the mounting door that was removed, hand tighten
these screws, overtighten can cause tread stripping and void
all warranties).
Make wire connections in the pole, observing proper voltage
and polarity. Connect green ground wire from the fixture to
the field ground wire. Secure wires; push back into pole and
replace pole cap.
To rotate the luminaire head:
Loosen the captive screws(KAX1-4; KAX2-6) on the main door
using a 3/16 allen wrench (Figure 6).
©2016 Acuity Brands Lighting, Inc.
All Rights Reserved.
Figure 6
Lithonia Lighting Outdoor
One Lithonia Way, Conyers, GA 30012
Phone: 800-279-8041 Fax: 770-918-1209
www.lithonia.com
Figure 4
Figure 5
Locate the rotation feature in the front compartment. Fully
remove the 4 – 1/4" bolts, this will free the head and allow it
to rotate (Figure 7).
Figure 7
Part Number: RJ521393 Rev A
Revision Date: 4/28/16