Motorola XTR446 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Двостороннє радіо Motorola XTR446. Motorola XTR446 17 сторінок. Pmr 446 two-way radios

Друкувати сторінку

6864234V01-A_EN Final2.fm Page 5 Monday, August 14, 2006 3:38 PM

Charging Status

The solid red indicator shows that the radio with NiMH

battery is charging. A depleted battery will recharge to

full capacity within 16 hours.

Note: When moving between hot and cold

environments, do not charge the radio until the

battery temperature acclimatises (usually about

20 minutes). For optimal battery life, remove the

radio from the charger within 16 hours. Do not

store the radio in the charger.

Turning Your Radio On and Off

SEL/

1.Press and hold

for approximately 2

seconds to turn your radio on.

2.The radio chirps and the display briefly shows all

feature icons that your radio has available.

The display then shows the channel number 1-8,

the interference eliminator code 00-38 and the

battery meter.

SEL/

3.Press and hold

for approximately 2

seconds to turn your radio off.

Volume

VOL/CH

1.Increase the volume by pressing the

button (+). To decrease the volume press the

side button (-). The volume level (0-7) is

displayed for 5 seconds.

Keypad Tones

Every time you press a button on your radio, it beeps -

except for PTT and ^.

To enable or disable keypad tones, press and hold ^

while switching your radio ON.

Battery Meter and Low Battery Alert

The battery level indicator

the display, indicates the battery status. When the

battery in the unit is low, the battery level indicator

flashes. The radio will sleep when the voltage drops

below a predetermined level, to protect the

rechargeable battery.

Battery Life

The approximate (typical) battery life for:

• AAA Alkaline batteries is 20 hours

• NiMH batteries is 14 hours

This is based on a 5% transmit, 5% receive and 90%

standby cycle.

Note: Battery life will be reduced if you regularly use

Hands-Free (VOX) accessories.

side

Belt Clip

VOL/

Your radio is supplied with two belt clips.

1.To attach, align the grooves of the belt clip with those

of the back of the radio. Slide the belt clip down-

wards until a click is heard.

2.To remove, pull the release tab away from the radio

back and slide the belt clip upwards.

, located in the top of