Motorola D1003 Посібник користувача - Сторінка 23

Переглянути онлайн або завантажити pdf Посібник користувача для Бездротовий телефон Motorola D1003. Motorola D1003 26 сторінок. Digital cordless phone
Також для Motorola D1003: Посібник користувача (45 сторінок), Посібник користувача (26 сторінок), Посібник користувача (50 сторінок)

Technical Information

How many telephones can I have?

All items of telephone equipment have a Ringer Equivalence Number (REN), which is used to

calculate the number of items which may be connected to any one telephone line. Your D1000 has a

REN of 1. A total REN of 4 is allowed. If the total REN of 4 is exceeded, the telephones may not ring.

With different telephone types there is no guarantee of ringing, even when the REN is less than 4.

Any additional handsets and chargers that you register have a REN of 0.

R&TTE

This product is intended for use within South Africa for connection to the public telephone network

and compatible switchboards.

This equipment complies with the essential requirements for the Radio Equipment and

Telecommunications Terminal Equipment Directive 1999/5/EC including compliance with ICNIRP

standard for electromagnetic energy exposure.

This product is intended for use within South Africa for connection to the public telephone network.

With some switchboards, after dialling the access code you may have to wait for a moment while

the switchboard picks up an outside line so you will need to enter a pause in the dialing sequence.

Press and hold

to insert a pause (P) before entering the telephone number.

You may also need to enter a pause when storing international numbers or charge card numbers.

You may need to use the recall function if you are connected to a switchboard/PABX (Private

Automatic Branch Exchange), contact your PABX supplier for further information.

Wall mounting

IMPORTANT

Before you wall-mount your D1000, check that you are not drilling into any hidden wiring or pipes.

Before you drill, make sure the power and telephone line cables will reach the sockets.

1. Use the following templates to mark the drilling locations.

• To wall-mount the base, drill two holes in the wall 4.5cm apart horizontally using an 8mm drill

bit.

• To wall-mount the charger, drill two holes in the wall 3.2cm apart horizontally using an 8mm drill

bit.