Epson TM-L90 series Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Виробник етикеток Epson TM-L90 series. Epson TM-L90 series 17 сторінок. Attaching cover on the power switch
Також для Epson TM-L90 series: Брошура (1 сторінок), Брошура (2 сторінок), Технічні характеристики (2 сторінок), Технічні характеристики (8 сторінок), Інформаційний посібник (5 сторінок), Технічні характеристики (4 сторінок), Почніть звідси. (2 сторінок), Почніть звідси. (2 сторінок), Посібник (13 сторінок), Інструкція з експлуатації (12 сторінок), Посібник (2 сторінок)

Друкувати сторінку

Epson TM-L90 series Посібник користувача

English

Power Switch and Power Switch Cover

The power switch is on the top left of the printer. Press it to turn on the printer,

and press and hold it for more than 3 seconds to turn off the printer.

Power Switch Cover

You can use the enclosed power switch cover to make sure that the power switch

is not accidentally pressed. Peel off the backing tape and press the cover into place

to install it.

WARNING:

If an accident occurs when the power

switch cover (shown to the right) is

attached, immediately remove the

bottom cover and unplug the power

supply cable to avoid a fire hazard.

Unpacking

The following items are included for the

standard specification printer. If any items are damaged, contact your dealer.

❏

Printer

❏

Label roll paper

❏

Power switch cover

❏

Roll paper spacer

❏

Screw for installation of roll paper spacer

❏

Cover operation label

Downloading Drivers, Utilities, and Manuals

Drivers, utilities, and manuals can be downloaded from one of the following

URLs.

For customers in North America, go to the following web site:

http://www.epsonexpert.com/ and follow the on-screen instructions.

For customers in other countries, go to the following web site:

http://www.epson-pos.com/

Select the product name from the "Select any product" pulldown menu.

Installing the Printer

Whether you are going to use the printer in the label peeler issuing mode or label

continuous issuing mode (not using the peeler), you must install this printer

vertically (with the paper exit at the front). See the illustration at the top of page 5.

You can install it either on a flat surface, or you can hang it on a wall by using the

optional bracket (WH-10).

If the paper exit is blocked by label backing paper accumulating on a table or other

surface, a paper jam or other problem may occur. Install the printer in a location,

such as at the edge of a counter, where the backing paper will not accumulate near

the paper exit.

4 TM-L90 with Peeler User's Manual