Epson 7850p - PowerLite XGA LCD Projector Інформаційний посібник про продукт - Сторінка 6

Друкувати сторінку

Epson 7850p - PowerLite XGA LCD Projector Інформаційний посібник про продукт

Starting Up the Projector

If you turn on your computer or video equipment before the

projector, the projector automatically selects the connected

source. If you turn on the projector first or you have multiple

sources connected, you may have to switch to the desired

source manually (see "Selecting the Image Source" on page 5).

Turning On the Projector

1. Remove the lens cap.

2. Plug in the projector.

3. Wait a few seconds until the projector's P power light stops

flashing and turns orange.

4. Press the red P

Power

the remote control.

Note: If you're using the remote

control, make sure batteries are

installed and the power switch on

the side of the remote control is

turned on.

The projector's P power light flashes green as it warms up,

and an image begins to appear after about 30 seconds.

When the P power light stops flashing and remains green,

the projector is ready for use.

Warning: Never look into the lens when the lamp is on. This

can damage your eyes.

5. If you've connected a Windows-based computer to the

projector, you may see a New Hardware Wizard saying

your computer has found a plug-and-play monitor; if so,

click

Cancel

Selecting the Image Source

If multiple devices are connected to the projector, you can use

the

buttons on the projector or the remote control to

Source

switch from one source to another:

button on top of the projector or on

Power button

EPSON PowerLite 7850p Projector

❏ The projector's control panel has two

Use the

Computer/DVI

switch between EasyMP,

between equipment connected to the

and

Computer

DVI

Use the

Video/BNC

between equipment connected to the

, and

Video

S-Video

❏ The remote control has six

buttons. Use them to switch

between equipment connected to

the port identified on each button,

or select

EasyMP

wirelessly or from a memory card.

You can preview all sources to help

you select the desired source, as described below.

The

and

Computer

input signals, so if you have equipment connected to one of

these ports, be sure to select the correct signal to match the

equipment you're using. You can change the input signal

settings using the projector's menu system as described in

"Types of Connections" on page 4.

Previewing Image Sources

Use the preview function to select the image source when you

have connected multiple sources to the projector.

1. Press the

Preview

remote control.

You see the currently selected

source displayed on the screen, as

shown below. Other sources

(including the currently selected source) appear in smaller

preview windows on the right and bottom of the screen.

Currently selected source

BNC

If no equipment is connected to a port, or if there is no

incoming signal, the preview window for that source

appears blank.

Note: Movies are displayed as still images on the preview

screen.

6/03

EPSON PowerLite 7850p Projector

Source

button to

™

and

ports.

button to switch

ports.

BNC

Source

to project

ports can be set up to use different

BNC

button on the

Preview

Computer (Analog-RGB)

Computer

DVI

Video

S-Video

Preview windows

buttons.