Epson ES-300C Бюлетень підтримки продукту - Сторінка 4

Переглянути онлайн або завантажити pdf Бюлетень підтримки продукту для Програмне забезпечення Epson ES-300C. Epson ES-300C 13 сторінок. Laser & non-impact printer error codes
Також для Epson ES-300C: Бюлетень підтримки продукту (19 сторінок), Посібник (8 сторінок), Додатковий посібник (15 сторінок), Посібник (11 сторінок), Бюлетень підтримки продукту (20 сторінок), Бюлетень підтримки продукту (14 сторінок), Бюлетень підтримки продукту (25 сторінок)

Друкувати сторінку

Epson ES-300C Бюлетень підтримки продукту

[E] PAPER OUT SET STD XXX

There is no paper in the standard paper cassette.

display prompts you to load the correct paper size into the standard paper

cassette.

[E] PAPER SIZE ERROR

The paper size you selected with SelecType (or the default size if

have not selected a size) does not match the paper loaded in the selected

paper cassette.

[S] PRINTING

The printer has received data and is printing.

[S] PRINT STOP X/X

The printer stops printing during a multi-copy print operation.

[S] RAM Check X.X MB

The printer is checking RAM (X.X = capacity).

[S] READY

The printer is ready to print.

[E] REINSERT CARD

If this message appears on the display, you

card or cartridge while the FEED light was still lit or while the printer

was on line.

EPL-7000 cont.

[E] REMOVE CARD

You may have inserted a font card or cartridge while the printer was on line

or while the FEED light was on.

[E] RESELECT TRAY

The optional lower paper cassette is not installed and the INPUT option is

set to OPT or AUTO.

[S] RESET

The printer is being reset to the previous settings in the macro specified

with LOAD MACRO option in SelecType Level 1.

[S] ROM Check

The printer is checking ROM.

[E] SAVE MEMORY OVERFLOW

If this message appears when you are trying to save a macro with the SAVE

MACRO option in SelecType Level 1, the printer does not have enough

memory to save any additional macros

[E] SERVICE REQ.

A controller error has been detected.

[E] SERVICE REQ.

A print engine error has been detected.

XX = 03 Fusing Unit (low temp)

04 Main Drive Motor

05 Ozone Fan motor

06 Polygon Mirror Drive

09 HSync Signal

[E] SET FULL PRINT

This message may appear when you are trying to print graphics or a mix of

text and graphics.

[S] STANDBY MODE

Cxxx

EOOXX

may

Data still remains in the printer's buffer.

The right column of the

have

removed

you

font