Toshiba 219X6M Посібник користувача Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача Посібник користувача для ТЕЛЕБАЧЕННЯ Toshiba 219X6M. Toshiba 219X6M 13 сторінок. Colour television ~11-sys tem
WELCOME
TO THE BRIGHT
NEW WORLD
OF
TOSHIBA
COLOUR
Your new, precision-built Toshiba Colour Television receiver has been designed and engineered by the world's largest maker of
IC's, transistors and diodes to give you the most dependable, most natural colour television reception possible today.
IMPORTANT
To enjoy your set to the full from the very beginning, read this handbook carefully and keep it handy for ready reference.
This set allows you to receive 11 systems, namely, PAL B/G, SECAM
B/G, PAL D/K, SECAM D/K, PAL !, NTSC Standard
(US M, JAPAN
M), NTSC 3.58/5.5 (VTR Play Back), NTSC 4.43/5.5 (VTR Play Back), PAL 50/60 Hz (VIDEO DISK Play
Back), SECAM 50/60 Hz (VIDEO DISK Play Back) and NTSC 50/60 Hz (VIDEO DISK Play Back).
INSTALLATION
@ LOCATE the receiver in the room where direct light does not strike the screen.
Total darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect lighting is recommended for
comfortable viewing.
@ POWER CONSUMPTION
of 219X6M is 100 watts and 289X6M is 152 watts at AC 220 volts/50 Hz.
m Automatic Degaussing:
All colour
television receivers are sensitive to magnetic influences, usually caused by either
moving the receiver from one place to another or using certain electrical appliances near the receiver. This residual magnet-
ism as it is called, sometimes causes distortion which gives rise to 'blotchy' areas of colour in the picture. To avoid these
effects the receiver incorporates an automatic degaussing circuit which operates for a short while immediately each time
the receiver is switched on using the mains switch. This circuit removes any residual magnetism in the metal parts of the
picture tube and therefore ensures that each time the receiver is switched "ON" using the Mains switch, the purity of the
colours
displayed
on the screen remain true and lifelike. If the set is moved
or faced in a different direction, the mains
switch must be switched off at least ONE hour in order that the automatic degaussing circuit operates properly.