Aeon Aeotec MultiSensor 6 Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари Aeon Aeotec MultiSensor 6. Aeon Aeotec MultiSensor 6 12 сторінок.

3. Insert the larger end of the USB cable into a computer or adapter. Your MultiSensor 6 is now powered on.

For a battery powered installation:

1. Remove your sensor's rear cover as shown in the previous step.

2. Insert two CR123A batteries orientated according to the diagram within your sensor. Your MultiSensor 6 is now powered

on.

Note: MultiSensor 6 can be powered by a single CR123A, though batteries will require changing more frequently. If

powering your MultiSensor 6 with a sole battery, insert it into the battery holder marked 1.

Adding your MultiSensor 6 into a ZWave Network.

With it powered on, it's now time to add your MultiSensor 6 to a ZWave network. To pair the Multisensor 6, you are not

limited to only the ZStick or Minimote. You may use any ZWave Gateway to pair the Multisensor 6, but compatibility and

how the sensor shows ultimately depends on the gateway and software integration of products.

If you're using a ZStick from Aeotec: