Pioneer VSX-530-K Посібник з експлуатації - Сторінка 17

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Стерео приймач Pioneer VSX-530-K. Pioneer VSX-530-K 32 сторінки. Pioneer vsx-1130-k; vsx-830-k; vsx-530-k av receivers
Також для Pioneer VSX-530-K: Довідковий посібник (27 сторінок), Посібник із швидкого старту (17 сторінок), Інструкція з експлуатації Посібник з експлуатації (39 сторінок)

4. EACH SETTING AND ADJUSTMENT

4.1 UPDATING OF THE FIRMWARE (IC3: SUB MICROCOMPUTER)

• The updating jig (GGF1642) in this Section is the same as that used for updating of the MAIN microcomputer of the base

model (VSX-523-K/CUXESM).

• The software for updating to be used on a PC is "FLASH MCU Programmer for FM0+/FM3/FM4."

Please download it from Service Website.

• The updating procedure for MAIN microcomputer is same as the base model (VSX-523-K/CUXESM).

Please refer to the Service Manual (RRV4418) for VSX-523 regarding it.

[Preparations]

1. Install the software for updating on the PC.

2. Unplug the power cord of the main unit.

Connect the FFC of the updating jig for updating to the

main unit.

(Orient the FFC so that the conductive surface of the

connector faces the triangular a symbol.)

Rear side

3. Start the software for updating on the PC.

[Procedures]

To perform updating, proceed as follows:

1. Set the values for Target MCU and Crystal Frequency,

as follows:

Target MCU: MB9AF156M/N/R

Crystal Frequency: 4MHz

2. Specify the software file to be updated.

Click on "Open"

to open the File Selection window.

Select Intel Hex files (*.hex) in File Type.

VSX-530-K

3. Specify the COM PORT.

Click on "Set Environment"

Environment Setting window.

Assign the COM PORT number 5, according to the

environment.

Click on "OK"

to close the Environment Setting

window.

4. Click on "Full Operation (D+E+B+P)"7.

5. After the window shown below is displayed, turn the

main unit on.

6. Press the Reset button of the updating jig for updating.

7. Click on "OK" 8.

to open the