Pioneer GM-A3702 Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Pioneer GM-A3702. Pioneer GM-A3702 33 сторінки. Bridgeable two-channel
Також для Pioneer GM-A3702: Посібник користувача (19 сторінок), Посібник користувача (33 сторінок), Посібник користувача (16 сторінок)

Друкувати сторінку

Connecting the units

Connections when using

the speaker input wire

Connect the car stereo speaker output wires

to the amplifier using the supplied speaker

input wire.

! Do not connect both the RCA input and the

speaker input at the same time.

1 Car Stereo

2 Speaker output

3 White/black: Left *

4 White: Left +

5 Gray/black: Right *

6 Gray: Right +

7 Speaker input connector

To speaker input terminal of this unit.

Note

If speaker input wires from a headunit are con-

nected to this amplifier, the amplifier will automa-

tically turn on when the headunit is turned on.

When the headunit is turned off, the amplifier

turns off automatically. This function may not

work with some headunits. In such cases, make

sure that the Left channel is connected correctly.

If the function still does not work, please use a

system remote control wire (sold separately). If

multiple amplifiers are to be connected together

synchronously, connect the head unit and all am-

plifiers via the system remote control wire.

Connecting the power

terminal

The use of a special red battery and ground

wire RD-223 (sold separately) is recom-

mended. Connect the battery wire directly to

the car battery positive terminal + and the

ground wire to the car body.

WARNING

If the battery wire is not securely fixed to the term-

inal using the terminal screws, there is a risk of

overheating, malfunction and injury, including

minor burns.

Route battery wire from engine com-

partment to the vehicle interior.

! When drilling a cable pass-hole into the ve-

hicle body and routing a battery wire thor-

ough it, take care not to short-circuit the

wire damaging it by the cut edges or burrs

of the hole.

After completing all other amplifier connec-

tions, finally connect the battery wire terminal

of the amplifier to the positive + battery term-

inal.

1 Positive + terminal

2 Engine compartment

3 Vehicle interior

4 Fuse (30 A) × 2

5 Insert the O-ring rubber grommet into the

vehicle body.

6 Drill a 14 mm (1/2 in.) hole into the vehicle

body.