Pioneer SX-980 Інструкція з експлуатації Посібник з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Підсилювач Pioneer SX-980. Pioneer SX-980 22 сторінки. Am/fm stereo receiver
Також для Pioneer SX-980: Інструкція з експлуатації Посібник з експлуатації (28 сторінок)
Друкувати сторінку
ee
FONE
KT
-- FOR USE IN UNITED KINGDOM OR AUSTRALIA
CAUTION 240V
nected to the terminal which is marked with the |
Mains supply voltage is factory adjusted at 240
letter L or coloured brown or red.
volts.
The AC Outlets of this apparatus have been re-
moved from this apparatus in order to comply
WARNING
with U.K. Safety Regulation. Ensure that your
THIS APPARATUS MUST BE EARTHED.
equipment is connected correctly—if you are in
IMPORTANT
doubt, consult a qualified electrician.
The wires in this mains lead are coloured in ac-
Do not unscrew the bottom plate and cabinet.
:
;
No user serviceable parts inside.
d
th the foll
de:
;
:
ree ht Nae.
ia
sa
Always disconnect all the equipment
from the
;
mains
supply
when
disconnecting
the
signal
Blue:
Neutral
leads. The Power cord should be connected last,
make sure that the Power switch is OFF. Be sure
the appliance connector is fully inserted into the
AC inlet.
Unplug the set from the wall socket when it is
not to be used for an extended period of time.
Brown:
Live
As the colours of the wires in the mains lead of
this apparatus
may
not
correspond
with
the
coloured
markings
identifying the terminals in
your plug proceed as follows.
The
wire
which
is coloured
green-and-yellow
must be connected to the terminal in the plug
FOR YOUR SAFETY
which is marked by the letter E or by the safety
1. Insert this plug only into effectively earthed
earth symbol ~
or coloured green or green-and-
three-pin plug-socket outlet.
yellow.
2.If any
doubt
exists regarding the earthing,
The wire which is coloured blue must be con-
consult a qualified electrician.
The wire which is coloured brown must be con-
INSTALLATION
CAUTIONS
Location liable to downgrade performance
Resulting
trouble
and result in breakdowns
9
1.
Locations exposed to direct sunlight, or near heaters.
1. External
heat causes
the performance
of the circuit
parts to
deteriorate, and operation becomes unstable.
2.
Locations
with
poor
ventilation,
or with
high humidity
or
2. Cause
of faulty contact
in input/output
terminals, and rust.
moisture contents, or dusty locations.
High humidity and a high moisture content cause deterioration
in insulation. There is also the danger of current leakage and
heat generation
in the circuit parts. Dust or grease in the rotat-
ing parts causes the parts to deteriorate.
3.
Locations susceptible to vibration.
3. These locations affect the precision parts adversely.
4.
Locations where an AM
radio or TV set is being used simulta-
4.
Mutual
interference can occur from the oscillator circuits used
neously.
in these products.
Don't put anything on the top of the receiver because high power receiver will produce a lot of heat. Also leave sufficient
around the receiver for adequate ventilation.
SL
mae ee
Na
Ta
a
a
|
3