Pioneer VSA-700 Посібник - Сторінка 24

Переглянути онлайн або завантажити pdf Посібник для Підсилювач Pioneer VSA-700. Pioneer VSA-700 30 сторінок. Av digital surround amplifier

Pioneer VSA-700 Посібник
USE OF LEARNING
FUNCTIONS
[Operation Example]
2.
Place the transmission
sections of the programmable
Using the remote control unit of your VCR to program the
remote control unit and the remote control of the VCR
playback command.
facing each other.
*
[tis recommended that the name of the key and its function
correspond. This is convenient when operating equipment.
1 to 2 inches
LEARN
TRANSMIT
USE,
LEARN
vi
2:8
AUDIO
BE
x
TAPE/VCR
DAT
—-VCR
CH+
@ LEARN indicator
This indicator shows the remote control unit operating condition.
LIT:
Learning is possible.
OFF:
Regular remote control functions are performed.
FLASHING:
When you forced to learn by the keys which can not learn.
@ TRANSMIT indicator
This indicator flashes when remote control signals are sent.
© LEARN selector switch
Set as follows:
LEARN:
This position is used for storing the codes of your remote control
unit.
USE:
Set to this position after codes have been stored in the LEARN
position. Set to this position for normal operation.
[Operation example]
1.
Setthe LEARN switch of the programmable remote control
unit to the LEARN position and set the TRANSMIT mode
selector switch to the VIDEO position.
¢
Programming is possible with the TRANSMIT
mode
selector switch in any position, but VIDEO is used as
an example.
24
<ARE1065 >
BORG GE
GORGES = &,
¢
Place the two units on a table, separated by 2 to 5 cm
(1 to 2 inches).
Memorization will not be possible if they are too close.
Hold down the VCR
PLAY
key of the programmable
remote control unit until the LEARN indicator lights up, then
release the key.
Hold down the PLAY key of the VCR remote control unit.
Release the key of the VCR remote control after making
sure that the LEARN indicator of the programmable remote
control has been extinguished.
NOTE:
If the LEARN indicator flashes, it indicates that you are trying
to preset a key not available for the learning function, or
otherwise the program capacity has been exceeded. In case
the program capacity has been exceeded, the function
programmed
last will not be memorized
correctly. All
previously programmed functions, however, will be retained
in memory and may be used as they are if the last function
is not essential.
For re-programming
refer to page 25
"Returning to the Initial Settings''.
Set the LEARN
selector switch of the programmable
remote control unit to the USE position.
e The previous code (Pioneer uniform remote control
code or code for other equipment)
is erased and
replaced by the new code.
Check that the program works.
¢ Try actual operation and make sure the unit works
properly.
e
If the VCR does not operate when pressing the key,
change angle, position and distance between both
remote control units and repeat the programming
procedure.
e¢ When
programming,
make
sure
that the function
indications (for example, » , >
, MI) on the other
remote control unit and the programmable
remote
control unit are the same. This will facilitate operation.