3Com 3CR990 Посібник із швидкого старту - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережева карта 3Com 3CR990. 3Com 3CR990 18 сторінок. Software for the 3cr990 network interface card (nic) family embedded firewall

Друкувати сторінку

Quick Start Guide

7 On the computer receiving the EFW NIC installation, run the setup.exe ﬁle

located in the temporary directory that was copied in Step 6. (For larger

installations of multiple NICs, you can simply run the installation from a

Verifying NIC Registration

The NIC automatically registers with the Policy Server on the ﬁnal reboot

that is required by the installation process. When the computer has ﬁnished

rebooting, the EFW NIC is displayed in the Management Console. To verify

that the EFW NIC registered correctly, follow the steps below.

1 In the Management Console, click the Device Sets tab in the lower left

corner of the window.

2 Select Edit -> Refresh.

3 Click on the Default Device Set in the tree-view frame. The NIC should be

listed in the default device set.

4 If desired, remove the temporary directory created for the NIC installation

package.

For information on other installation methods, refer to the section

"Distributing and Installing the EFW NIC Firmware" in the 3Com Embedded

Firewall Administration Guide.

Changing the Policy for an EFW NIC

You can allow all EFW NICs to register with the default device set, and then

move them to a different device set at a later time. To demonstrate this move,

you will:

create a rule set,

create a policy and add the new rule set,

assign the new policy to a device set, and

move the EFW NIC to the device set.

NOTE: Before you change the policy for the EFW NIC, test your Internet

access to ensure that the system hosting the EFW NIC can navigate

to the 3Com Web site, by connecting to www.3com.com. In a later

section, you will attempt to access the same Web site, which at that

point should be denied by the policy being enforced.