Pioneer PD-S701 Інструкція з експлуатації Посібник з експлуатації - Сторінка 15
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Програвач компакт-дисків Pioneer PD-S701. Pioneer PD-S701 22 сторінки. Compact disc player
Також для Pioneer PD-S701: Інструкція з експлуатації Посібник з експлуатації (32 сторінок)
Друкувати сторінку
TO PLAY ONLY DESIRED TRACKS
Programming a pause
]
| To check the program contents
|
inserting a pause in your program can be very useful when carrying
out recording. Press #f instead of entering a track number.
"PA"
appears on the display.
For example, when recording on both sides of a cassette tape,
if you program a pause after the last track to be recorded on
the first side, program playback will pause at that point to aliow
you to switch tape sides, To resume program playback after the
player enters pause mode, press IE.
NOTES:
e
A pause can be programmed only when the program procedure
is performed under stop mode.
A pause cannot be programmed at the beginning of a program,
nor can two pauses be programmed one after the other.
A pause inserted in a program is counted as one step.
If a pause is programmed as the last step of a program, the
player will not enter the pause mode.
To clear all of the program contents
|
®
OPEN/CLOSE
"BSE
®
During stop mode, press mi.
When the disc tray is ejected, the program contents will be
cleared,
|
To erase a program
|
PD-S801
=
CLEAR
CLEAR
PD-S701
CLEAR
»* []
.
J?)
OF Sg
During program mode, press CLEAR.
qT
Pp
he last program step is erased and the contents of the previous
fagram step are displayed.
NOTE:
Contents of a program can be erased during playback as well.
However,
tracks preceding the currently playing track cannot be
erased in this way.
PD-S801
PD-S701
PD-S701
CHECK
Ft;
anal
u
Sd
1. With the player in the program stop mode, press CHECK.
@
Each time the button is pressed, the programmed tracks willbe
displayed in the order they were programmed.
2. After confirming the last program step, the track number display
will show "00".
3. When CHECK is pressed again, the display will return to that
shown in step 1
To modify the program contents
1
pp-ss01
PD-S701
CHECK
1. Press CHECK so that the program step to be corrected appears on
the display.
2. Enter the new track No. with the digit buttons. For example, the
programmed track No. 3 in step 2 is changed to track No. 7, using
the [7] button.
@
Repeat steps 1 and 2 to change other tracks as desired.
15.
<PRBi171>
En