Pioneer PIONEER S-IC621D Інструкція з експлуатації Посібник з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Акустична система Pioneer PIONEER S-IC621D. Pioneer PIONEER S-IC621D 17 сторінок. Architectural loudspeaker
Також для Pioneer PIONEER S-IC621D: Брошура та технічні характеристики (8 сторінок), Технічні характеристики (1 сторінок)
Друкувати сторінку
14 Adjust the angle of the tweeter.
Gently press the edge of the tweeter flange to adjust the
angle of the tweeter as desired. Be careful not to touch
the diaphragm while doing this.
15 Adjust the setting of the treble control as
necessary.
• The standard setting is 0.
• The treble switch located in the front of the speaker
has two positions to choose from, +/0.
16 Attach the butyl rubber tapes on the inside of the
grille.
Attach the eight butyl rubber tapes
to each grille, lining up the butyl
rubber tapes to the marks on the
inside of the grille.
Then peel off the protective paper.
17 Attach the grille to the speaker.
The grille is designed with a specific mounting
orientation. Gently push the grille onto the speaker, lining
up the one section of the edge of the grille to the groove
in the speaker. Then line up the entire grille to the groove
in the speaker and attach the grille by pressing in all
around the edge.
Orientate the grille so that the
notch is positioned adjacent to
the Pioneer logo.
Make sure to press on the
edges. Pressing on the
middle of the grille will
cause it to be deformed.
• Once you have pushed it in, make sure you press it
firmly against the speaker so that the grille doesn't
fall off and cause an accident.
6
En
• To remove the grille, use the supplied tool to hook
into the holes located near the edges and pull the
grille out. When doing this, make sure to pull the
edges out evenly. Forcing the grille out from one edge
alone will cause the grille to be deformed.
Make sure not to
touch the
diaphragm as it can
be easily damaged.
Connections
Connecting to an amplifier
Make sure you have read the connection instructions in
the manual supplied with the amplifier and that all
equipment is turned off before making any connections.
• When using a set of speakers connected to an
amplifier, you won't be able to obtain the correct
stereo effect if the polarity (+, –) of one of the
speakers (left or right) is reversed.
Additional Information
Cleaning the speaker
Use a dust brush to wipe off dust and dirt.
Never use furniture wax, cleaners, thinners, benzine,
insecticide sprays or other chemicals on or near the
speakers, since these will corrode the surfaces.