Aeotec Door Window Sensor Gen5 Посібник користувача - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари Aeotec Door Window Sensor Gen5. Aeotec Door Window Sensor Gen5 7 сторінок.
Друкувати сторінку
1. Remove your Sensor unit from its Back Mounting Plate, press the Action Button on the back of the Sensor unit
and then release the Action Button. This will trigger and send a wake up notification command to your
controller/gateway.
2. If you want your Sensor to keep awake for a longer time, press and hold the Action Button on the back of the
Sensor unit for 3 seconds, then your Sensor will wake up for 10 minutes and the Status LED will fast blink while
it is awake.
Removing your Sensor from your Z-Wave Network.
Your sensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's main
controller/gateway. To do this, please refer to the part of their respective manuals that tell you how to remove devices
from your network.
1. Put your primary controller into device removal mode.
2. Unlock your Sensor from the Back Mount plate and take the Sensor unit near to your primary controller.
3. Press the Action Button on your Sensor.
4. If your Door Window Sensor has been successfully removed from your Z-Wave network, its Status LED will fast
blink for 8 seconds and then slow blink for 3 seconds when you press the Action Button again. If the removing
was unsuccessful, the Status LED will fast blink for 2 seconds and then be solid for 2 seconds when you press
the Action Button, repeat the above steps.
Include Sensor as a non-secure device.
If you want your Sensor as a non-security device in your Z-wave network, you just need to press the Action Button
once on Door Window Sensor when you use a controller/gateway to add/include your Sensor.
Include Sensor as a secure device.
In order to take full advantage of all functionality the Door Window Sensor, you may want your Sensor is a security
device that uses secure/encrypted message to communicate in Z-wave network, so a security enabled
controller/gateway is needed for the Door Window Sensor to be used as a security device.
To do this:
press the Sensor's Action Button 2 times within 1 second when your security controller/gateway starts the
network inclusion.
Factory Reset Sensor.
If your primary controller is missing or inoperable, you may wish to reset all of your Door Window Sensor's settings to
their factory defaults. To do this:
Press and hold the Action Button for 20 seconds and Status LED will be solid for 2 seconds to confirm a
success.
More Advanced Configurations.