Whirlpool 3354199 Інструкція з монтажу Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Пральна машина Whirlpool 3354199. Whirlpool 3354199 8 сторінок.

Друкувати сторінку

the other end of the

shipping strap from the back of the

washer. The shipping strap plug must be

completely

removed from the washer

forthe self-leveling legs to be released.

Discard shipping strap.

If entire strap is not removed,

washer

may vibrate

and be noisy.

Use new hoses and washers that

came with your Whirlpool

washer.

coupling

washer

Insert a flat washer into each end of

the inlet hoses. Check that washers are

firmly seated in couplings.

inlets are plastic;

crossthread.

Attach hose to bottom inlet

W valve opening first. Then

second hose to top inlet. Tighten

couplings by hand; then use pliers to

make an additional two-thirds turn,

Floor Damage

Slide washer onto cardboard

hardboard

before moving across

floor.

Failure to do so may cause

damage

to floor covering.

Move washer close to final

position. Put "hook" end of

drain hose into standpipe.

Estimate

length of drain hose needed

when

washer is in final position. Hose must

be cut exactly to length so "hook"

end is held tightly over edge of

standpipe.

If drain hose is to

long - cut straight end of hose. (Do

/&z,ut

"hook" shaped end of drain

DO NOT FORCE DfCESS LENGTH OF

DRAIN HOSE DOWN THE STANDPIPE.

THIS COULD CAUSE SIPHONING.

Place hose clamp

over washer drain

connector. Push

drain hose onto

washer connector. Use pliers to open

clamp and slide clamp over drain

hose. Check for good fit.

I I I I

I-'

Put "hook" end of drain hose back

into standpipe.

Allow space

between

the standpipe

and drain

hose for an air gap. Too tight of a fit

could cause siphoning.

CHECK THAT HOSE IS NOT

TWISTED OR KINKED AND IS

SECURELY IN PL&E-

Before attaching

water inlet hoses,

run water through both faucets into a

bucket to get rid of particles in water

lines.

Attach bottom hose (inlet marked "H")

to hot water faucet. Attach top hose

(inlet marked "C") to cold water faucet.

Tighten coupling to faucet by hand,

then use pliers to make final two-thirds

turn.

Carefully tilt washer

backward

until front of

washer is 3-4 inches off of floor. Insert

1 or 2 corner posts.

I I

nut

Use legs and

nuts from parts

package.

Screw nut down to within

M" of base.

into correct

holes at each

front corner of washer until nuts touch

washer. Do not tighten nuts until step 15.

13.

Tilt washer backward

and remove

corner posts. Gently lower washer to

floor,

Move washer to its

permanent location.

Tilt washer forward raising back legs

1" off of floor. Gently lower washer to

floor. Check levelness at the washer

front and from front to back on each

side using a carpenter's level.